Application & Technology

The given data has been calculated based upon bending material with a tensile strength of δb =420 MPa over a length of 1m. Read More

The compensation system can effectively compensate the deflection deformation of the bending machine. Using the compensation system on the upper beam or lower beam can ensure the consistency of the bending angle in the whole length. Read More

Stainless steel polishing process can be divided into two parts: polishing and light out.The two-part processes and methods are now summarized as follows: Read More

The program stops during the execution process During the execution process, when non-machine tool emergency stop alarm or stop button stop, after eliminating the alarm and reset the alarm button on the main operation panel. If the console should better press "RETRACT" to raise the Z axis, and then Read More

Laser cutting is the laser beam through the focus mirror into a small light projection to the metal surface, the focus to achieve a high power density, when the material is quickly heated to the vaporization temperature, evaporation to form a hole, with the beam and the material relatively linear mo Read More

Warning: 1, overhaul any part of the hydraulic system, must be conducted by skilled personnel after a complete understanding of its principles and performance; 2 The maximum operating pressure of the hydraulic system is 26 MPa.If the working pressure exceeds the rated or maximum pressure, it can damage the mechanical parts and cause irreparable damage. This parameter has been adjusted at the factory, so random adjustment is not allowed. Read More

4.1 Often used are 88 ° (R1), 30 ° / straight knife (R1/R0.5), 88 ° (R1), 88 ° (R1/R0.5) and flat mold, and special upper knife mold.4.2 Lower modes include: single / double V lower modes, angle of 30 ° and 88 °, V4,V 6,V7,V8,V10,V12,V16,V25 (mm) 4.3 Selection of the machete mold is generally based Read More

Traditional bending process is under the pressure of the upper and lower die of the bending machine, using the two edges of the lower die opening and the top edge of the upper die to bend the sheet metal, the sheet metal through the process of elastic deformation to plastic deformation. The bending Read More

The reference table is used for the bending mold. Read More